Shelf Walls

After that fix poryadovke plummet and moor to poryadovke cord with inner-prichalku hand corner of the shelf. After installing the spread poryadovok beacons as ubezhnoy shtraby. Shtraba – this is a site that is laid before the break in to the resumption of work was provided by the correct ligation sutures. When attaching the cord-prichalki bracket, its pointed end into the seam hammered masonry. blunt end rests on a brick lighthouse on it and attach the cord-prichalku. The cord is not slack, enclose it under the wooden wedge thickness equal height of masonry and brick placed on top for clamping the cord.

Masonry walls of brick are as follows: 1. brick walls are laid out on 2. spread a solution of 3. (As opposed to Mitsubishi). spread outside of a mile. The walls and piers spread in single-row (chain) or multi-row system. Bonder series are made of a brick, regardless of the accepted system of dressing. They must lay out in the first (lower) and upper (last) series of masonry on level-edged walls.

Use half a brick in the back filling is permitted, under the windows (in malonagruzhennyh structures). All joints in the bridge, pillars, piers should be filled with a solution other than masonry vpustoshovku (not 1.5 cm). Nepolnomernye bricks (1 / 2, 1 / 4, 3 / 4) are placed side chipped off in the middle of the stack. Wall thickness is determined by the number of stacked bricks 1, 1 1 / 2, 2 bricks, etc. (Respectively 250, 380, 510 mm). Partitions do in 1 / 4 or 1 / 2 brick (65 and 120 mm). The strength of masonry depends on the strength of the solution, the location of the bricks, the thickness of the seams. The use of hollow brick and porous improves thermal properties of masonry. To make the clutch, but a solid (full) brick to be installed nepolnomerny brick – 1 / 2 brick. To do this, it cut down. Nepolnomerny brick used for the correct ligation joints, junctions, intersections of walls, vertical restraints, while laying piers and pillars. To obtain nepolnomernogo brick should: 1) on the arm kirochki note the size of a brick nepolnomernogo (four, half and trehchetverki), 2) attaching the handle to the brick, make a notch, appropriate length nepolnomernogo brick. Line of stumps of brick hammer mark blade, and then knurled kirochki first blow on the spoon on the one hand, and then another severe blow to the marked line. Strike applied perpendicular spoon, otherwise cut off the end of an oblique. If you need to split the brick along, it is first applied to the lungs through otrubki, at the end of his split with the required parts. Bricks can be cut, Using a trowel edge.